Log inGet started
World

High Ground: Climbing, Ledges, Vaults and Rooftop Running Kit

Branchmain
Branchesmain
Commite1311f0fc8

README.md

ClimbRig (traversalKit)

How a climber looks and sounds, on every peer. Put it on the same body as Traverser and climbKit's ClimbMover. It writes no synced state, so it runs everywhere and every player sees every climber the same way.

  • Animation: crossfades the kit's climbing clips (anims/: climb up/side/idle, ladder, rope, hang, shimmy, mantle, vault, wall run, balance walk/wobble, slip, land roll) on the body's own Locomotion graph and back to walking, at the speed the climber moves and the feel's animSpeed.
  • Hands and feet on the holds: four IKLimbs (the engine's IK): hands on the ledge edge while hanging or pulling up, hand over hand on the wall while climbing (on the rungs of a ladder), round the rope on a rope; feet on the wall, rungs or rope.
  • Facing: turns the body the way a traversalKit move goes (rope, vault, wall run, balance); climbKit faces its own moves.
  • Sounds: each hold kind's own grab, hand, foot and slip sounds plus vault, hard-landing, wobble and pull-up (holdSounds.module, through soundstage).
  • Feedback: juiceKit landingHard, shakeLight on a slip or a helped catch, dust on a vault, fired once from the owner's peer (juiceKit shows it to everyone).
FieldDefault
animatetrueplay the climbing clips
placeHands / placeFeettrueIK on hands / feet
soundstruehold sounds
feedbacktruejuiceKit feedback
volume1hold sound volume

The clips are made with the engine's animation generator (anim_gen) on a humanoid rig and play on any humanoid avatar; anims/clipImport.module takes out their travel, blends the loops' seams and trims the one-shots to the move. Replace any clip with your own by putting a clip of the same name in its folder (its play rate and length are set in RATE and LENGTH at the top of this component).