source_rig.json
Versions
Every version of this package its world published, newest first by when it first appeared. A version published again later keeps its place.
Upgrade @builtin to 2c02fe3 (the editor flagged the older pin as hiding the world from players) --- climbKit 1.1.11 (to send upstream): a ledge let go of is not re-caught; traversalKit Traverser keeps a dropping body where the ledge below can be caught --- climbKit 1.1.12: follow-ups from the reviews of PRs #4, #6, #7 and #8 --- climbKit 1.1.12: review points on #9 (refuse hang spot before takeover, kept push lapses, in-air guard skips only the pull-up) --- climbKit 1.1.13: review points on #9 --- climbKit 1.1.14: review nits on #9 --- traversalKit 1.0.9: 15 climbing clips from the engine's animation generator (in place, loop seams, one-shots trimmed; clipImport replaces the hand-keying author); climbKit 1.1.14; README versions --- Gallery check; tidy
01M7KJJWZ5T2CK4EKJX0Y0DQ89ebab6eb554Browse filesCompare with previousCompare from hereInstall climbKit, controlsKit, navKit, juiceKit, soundstage, alpineKit, inkBlocks, masonry and woods materials --- climbKit 1.1.1: review fixes (corner/latch reset, ledgeTopY on corners, owner guards, warn-once rules) --- traverseKit: holds, feels, assists, rules, Traverser, ClimbSurface, TraverseZone, hold sounds, keyed anims; gallery scene --- climbKit 1.1.2: read the controller bus first while a move runs (controlsKit schemes climb) --- climbKit 1.1.2 version bump and docs --- climbKit 1.1.2: keep map direction when the bus carries only a jump; doc bus scale --- climbKit 1.1.3 --- traverseKit: ClimbRig, ClimbFollower, TraverseHud, kit module, in-place one-shot clips, READMEs, guides, tests; gallery with controls, followers and HUD --- SceneGate between gallery and Ridge Run; notes and reviews of installed parts --- gallery: climbing guard posted at the stone wall --- Ridge Run: kit equipped, ClimbSurface holds, feel/assist switchers, level fixes from full playthrough, medal times --- traverseKit: gentler nimble/acrobat pull-up timing (two-player check) --- climbKit 1.1.4 (overhang, ignore lists); traverseKit: rope top pull-up, no rope re-grab, beam-axis balance, guard spacing --- climbKit 1.1.5: review notes (exclude on tryHang wall probe, README methods); traverseKit beam centreline pull --- Two-player check, guard spacing, rope/balance/overhang fixes (climbKit 1.1.5), Ridge Run startup, notes --- Two-player check, guard spacing, rope/balance/overhang fixes (climbKit 1.1.5), Ridge Run startup, notes --- holdSounds: tree foot uses the package's own clips (forestKit was not installed)
01M7ABM76GT813K3CA9SMJKDHA4a18314aacBrowse filesCompare from here